Home Page The Club Computers News Links Glossary EYAWTK
Before Amiga Background ICS OCS ECS AGA ??? PPC
U-Boot SLB Linux Amiga OS Dual Boot Motherboards Peripherals Other
Initialisation Installation OS4 Updates About OS4 File Systems Networking Printing Other
Introduction File System Workbench Preferences Commands Error Msgs Miscellaneous

AmigaOS 4.0 - About OS4 - Commands

ENDCLI Internal
Purpose: To end a Shell process.
Format: ENDCLI
Template: (none)
Path: Internal
ENDCLI ends a Shell process.

The Shell process can also be ended by ENDSHELL or clicking on the Close gadget.

ENDCLI should only be used when the Workbench is loaded or another Shell is running. If you have quit the Workbench and you close your only Shell, you will be unable to communicate with the Amiga. You only recourse is to reboot.

The Shell window may not close if any processes that were lauched from the Shell are still running. Even though the window stays open, the Shell will not accept new input. You must terminate those processes before the window will close. For example, if you opened an editor from the Shell, the Shell will not close until you exit the editor.

See also: ENDSHELL

Return to Commands Selection

Disclaimer: Amiga Auckland have prepared the above information for the use of its members based on our experiences and as such is subject to revision at any time. Amiga Auckland cannot guarantee any of the information and cannot be held accountable for any issues that may result from using it.

Copyright 2006 Amiga Auckland Inc. All rights reserved.
Revised: February 9, 2006.