Home Page The Club Computers News Links Glossary EYAWTK
Before Amiga Background ICS OCS ECS AGA ??? PPC
U-Boot SLB Linux Amiga OS Dual Boot Motherboards Peripherals Other
Initialisation Installation OS4 Updates About OS4 File Systems Networking Printing Other
Introduction File System Workbench Preferences Commands Error Msgs Miscellaneous

AmigaOS 4.0 - About OS4 - Commands

BINDDRIVERS Obsolete
Purpose: To bind device drivers to hardware.
Format: BINDDRIVERS
Template: (none)
Path: C:BINDDRIVERS

This command became obsolete with AmigaOS 4.0 Final - details shown for information only

BINDDRIVERS was used to load and run device drivers for add-on hardware that was automatically configured by the expansion library.

The device drivers must be in the SYS:Expansion directory, for BINDDRIVERS to find them.

BINDDRIVERS is normally placed in the Startup-sequence file. If drivers for expansion hardware are in the SYS:Expansion directory,you must have a BINDDRIVERS command in your Startup-sequence file or the hardware will not be configured when the system is booted.

Return to Commands Selection

Disclaimer: Amiga Auckland have prepared the above information for the use of its members based on our experiences and as such is subject to revision at any time. Amiga Auckland cannot guarantee any of the information and cannot be held accountable for any issues that may result from using it.

Copyright © 2006 Amiga Auckland Inc. All rights reserved.
Revised: December 24, 2006.